PTO or Cruise Control Does Not Operate

Symptom Tree  t112

This is symptom tree t112
Cause Correction

Electronic fault codes active or high counts of inactive fault codes

Refer to Section TF for fault code troubleshooting.

 

Programmable parameters or selected features are not correct

Check the programmable parameters and the selected features with an electronic service tool. Set the parameters and features again if necessary. Refer to the appropriate electronic service tool manual.

 

Electronic control module (ECM) calibration is malfunctioning

Verify the ECM calibration is correct. Check the calibration revision history for applicable fixes to the calibration stored in the ECM. Refer to the calibration history spreadsheet Click here to see ecm_calibration_rev_history.xls

on QuickServe® Online or the INCAL™ CD-ROM. Compare the calibration stored in the ECM with the engine rating and Control Parts List (CPL), Bulletin 4021326 or 4021327. If necessary, recalibrate the ECM. Refer to the appropriate electronic service tool manual and Procedure 019-032.

 

Vehicle speed sensor (VSS) or circuit is malfunctioning

Check the vehicle speed sensor and circuit. Refer to Procedures 019-090 and 019-091.

 

Clutch switch or circuit is malfunctioning

Check the clutch switch adjustment, switch, and circuit. Refer to Procedures 019-009 and 019-010.

 

Engine brake on/off switch or circuit is malfunctioning

Check the engine brake on/off switch and circuit. Refer to Procedures 019-034, and 019-035.

 

Vehicle brake switch or circuit is malfunctioning

Check the vehicle brake switch and circuit. Refer to Procedure 019-088.

 

Cruise control/PTO on/off switch or circuit is malfunctioning

Check the cruise control/PTO on/off switch and the circuit. Refer to Procedures 019-021 and 019-022.

 

Cruise control/PTO selector switch or circuit is malfunctioning

Check the cruise control/PTO selector switch and circuit. Refer to Procedures 019-023 and 019-024.

 

Cruise control does not operate.

Check for vehicle speed with an electronic service tool, using the monitor mode. Check OEM battery cables and grounds. They must meet OEM specifications for voltage drop under electrical load. Remove the alternator belt, if vehicle speed goes to zero, repair the alternator. Check for loose pick up gear on (VSS). Refer to Procedures 019-021, 019-022, 019-023, and 019-024.

 

Engine position sensor (EPS) or circuit is malfunctioning

Check the engine position sensor and circuit. Refer to Procedures 019-038 and 019-039.

 
Last Modified:  03-Feb-2004

Leave a Reply

Your email address will not be published. Required fields are marked *