Posted on by

Electronic Control System Signature, ISX and QSX15 Engines – FAULT CODE 428

Water-In-Fuel (WIF) Sensor Circuit


Overview

CODE REASON EFFECT
Fault Code: 428
PID: P097
SPN: 97
FMI: 3/3
LAMP: Yellow
SRT: 

High voltage detected at water-in-fuel (WIF) sensor circuit.

None on performance.
Water-In-Fuel (WIF) Sensor Circuit
SMALL | MEDIUM | LARGE

Circuit Description

The water-in-fuel sensor is attached to the fuel filter. The water-in-fuel sensor sends a signal to the electronic control module (ECM) when a set volume of water has accumulated in the fuel filter. The water-in-fuel circuit contain two wires: A return ground (pin 10) and a signal wire (pin 9).

Component Location

The water-in-fuel sensor is installed in the fuel filter and is located on the side of the head, approximately midengine.

Shop Talk

Possible causes for this fault code include:Short circuit to a (+) 5-VDC supply wire.

Refer to Troubleshooting Fault Code t05-428.

Last Modified:  26-Oct-2010
Avatar photo

Published by Jack

Hello, I'm Jack, a diesel engine fan and a blogger. I write about how to fix and improve diesel engines, from cars to trucks to generators. I also review the newest models and innovations in the diesel market. If you are interested in learning more about diesel engines, check out my blog and leave your feedback.