CM2150 Electronic Control System – FAULT CODE 2351

  Printable Version

Overview

ISB, ISC, and ISL with CM2150 – EGR Valve Position Circuit SMALL | MEDIUM | LARGE

Circuit Description

The exhaust gas recirculation (EGR) valve is opened by a motor located on top of the EGR valve. A motor shaft extends from the motor and contacts the dual-poppet valve to open the EGR valve. The EGR valve motor does not actually retract the EGR valve. The motor current is reduced and the spring pushes the EGR valve closed.

Component Location

The EGR valve is located on the air intake connection. Refer to Procedure 100-002 (Engine Diagrams) in Section E for a detailed component location view.

Conditions for Running the Diagnostics

This diagnostic runs continuously when the keyswitch is in the ON position.

Conditions for Setting the Fault Codes

The electronic control module (ECM) detects a short circuit in the EGR motor supply circuits.

Action Taken When the Fault Code is Active

• The ECM illuminates the amber CHECK ENGINE light immediately when the diagnostic runs and fails.
• The EGR valve operation will be disabled.

Conditions for Clearing the Fault Code

The ECM will turn off the amber CHECK ENGINE light immediately after the diagnostic runs and passes.

Shop Talk

Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe™ Online for applicable fixes to the calibration stored in the ECM. If necessary, recalibrate the ECM. Refer to Procedure 019-032 (ECM Calibration Code) in Section 19 in the corresponding Troubleshooting and Repair Manual for the engine being serviced.

Possible causes of this fault code include:

• EGR motor circuit shorted to ground
• EGR motor circuit shorted to battery supply.

Refer to Troubleshooting Fault Code t05-2351