Fault code information
2 trip MIL
3 drive cycle recovery
Readiness group – None
Freeze frame type -Comprehensive
Description of component(s)
Location of component(s)
Diagnostic condition
This diagnostic runs:
* when the ignition is switched on (NO engine start), and;
* ambient temperature is more than -20°C [-4°F]
Set condition of fault code
The PCI ECU (D420) detects that the measured pressure before turbine sensor reading differs by more than 0.36 bar [5.2 psi] from the average of other pressure sensor readings on the engine for more than 5 seconds.
Reset condition of fault code
To validate the repair, key on the ignition (NO engine start) and wait for 10 seconds to allow the system to power up and the diagnostics to run.
Electrical diagram(s)
Technical Data
Possible causes
Pressure sensor before turbine deviation
Additional information
For this diagnostic, the pressure sensor before turbine (F826) reading is compared with an average of other pressure sensor readings on/off the engine.
Es de gran ayuda la información
como puedo conseguir información para suscribirme con ustedes?