Paccar MX-13 – Removing crankshaft seal ring, front cover

1. Clean the area around the crankshaft seal ring thoroughly.

2. Install the spindle (A) of the special tool (1453185) to the crankshaft flange using the bolts (B).

3. Adjust the pin (D) with the bolt (F) until the distance (X) is 10 mm.

4. Lock the pin (D) with the nut (E).

5. Install the adapter (C) to the spindle (A) and secure it with the nut (G).

6. Turn the pin (D) into the adapter (C) and keep turning it until the stop is reached.

7. Repeat step 6 for the other five holes.

8. Fit screws (H) into the hole created in the seal ring.

9. Repeat step 8 for the other five holes.

10. Remove the nut (G).

11. Evenly turn the bolts (I) until the seal ring is removed.

Special tools

Special tool category: Mandatory special tool for: NA region, NA Service Support 1453185

Assembly and disassembly tool set for front and rear crankshaft seals




Leave a Reply

Your email address will not be published. Required fields are marked *