Posted on by

019-200   Connector, Pass Through

Table of Contents

Remove
Install

Remove

 TOC

The connectors connect the actuator connector of the engine harness to each of the injector solenoid wires in the rocker lever housing.

  
SMALL | MEDIUM | LARGE


Disconnect the actuator connector from the pass-through connector. Remove the capscrew.

Cut and remove the cable tie that holds the actuator harness to the pass-through connector.

Pull the pass-through from the rocker box housing.

Disconnect the injector solenoid wires from the pass-through connector.

SMALL | MEDIUM | LARGE
   

Install

 TOC

Install the new pass-through connector. Connect the pass-through connector to the injector solenoid wires. Insert the pass-through into the rocker lever housing. Tighten the capscrew.

Torque Value:  15  n.m  [133 in-lb]

Connect the actuator connector to the pass-through. Install a new cable tie, Part Number 3062329.

SMALL | MEDIUM | LARGE
Last Modified:  10-Feb-2003
Avatar photo

Published by Jack

Hello, I'm Jack, a diesel engine fan and a blogger. I write about how to fix and improve diesel engines, from cars to trucks to generators. I also review the newest models and innovations in the diesel market. If you are interested in learning more about diesel engines, check out my blog and leave your feedback.

Leave a Reply

Your email address will not be published. Required fields are marked *