Cummins N14 STC, Celect, Celect Plus – Service Manual 001-008   Camshaft

NOTE: The oil grooves on the thrust washer must be toward the camshaft gear to prevent thrust washer malfunction.

Apply a film of Lubriplate® 105, or equivalent, to both sides of the camshaft thrust washer.

Install the thrust washer onto the camshaft.

Install four camshaft pilots, Part Number 3375268, over the outer base circle of the valve lobes between the camshaft journals.

Use a rubber band to hold the installation pilots in place. The rubber band

must
straddle the valve lobes.

Apply a film of Lubriplate® 105, or equivalent, to the camshaft journals and the camshaft bushings.

Rotate the camshaft slowly as it is being installed into the cylinder block.

Align the “O” mark on the camshaft gear with the “O” mark on the crankshaft gear.

Align the timing marks on the camshaft gear with the timing marks on the accessory drive gear.

After aligning the “O” marks, push the camshaft into the bore until the thrust washer fits against the cylinder block.

Remove the camshaft installation pilots. Do

not
allow the rubber bands to fall into the camshaft cavity of the cylinder block when removing the installation pilots.

Use a dial indicator to check the backlash between the camshaft gear and the crankshaft gear.

Place the tip of the dial indicator against a tooth on the camshaft gear.

Turn the camshaft gear by hand as far as it will freely move, and set the dial indicator at “0” (zero).

Turn the camshaft gear by hand in the

opposite
direction as far as it will freely move, and read the dial indicator.

Backlash Between the Camshaft and Crankshaft Gears

If the backlash is excessive, inspect the camshaft and crankshaft gears for tooth wear and replace if necessary. If the backlash is tight, inspect for debris or damage to the gear teeth and check again.