The CM2150 Aftertreatment Exhaust Gas Temperature Sensor is a device used to measure the temperature of the exhaust gas after it has exited the engine…

The Bosch Aftertreatment DEF Controller Connector is a multi-pin connector that connects the DEF controller to the wiring harness. It is located on the DEF…

Table of Contents General Information Ordering the Customized Parts Catalog   Ordering by Telephone Ordering On-Line General Information TOC Cummins is pleased to announce the…

Table of Contents Pin Replacement   53 Pin Connector 86 Pin Connector Removing Terminal Inserting Terminal Pin Replacement TOC This connector is used to attach…

Table of Contents General Information Preparatory Steps Remove Inspect for Reuse Install Finishing Steps General Information TOC Exhaust gas temperature sensors are used to measure…

View Related Topic Table of Contents General Information Remove Inspect for Reuse Install General Information TOC The crankcase pressure sensor is used to monitor the…

Table of Contents General Information Test Initial Conditions Preparatory Steps Remove Clean and Inspect for Reuse Install Finishing Steps General Information TOC The aftertreatment diesel…

Table of Contents General Information Resistance Check Check for Short Circuit to Ground Check for Short Circuit from Pin to Pin General Information TOC The…

Table of Contents General Information General Information TOC ECM ROM Boot Procedure: Install the calibration cable with ROM boot switch. With the keyswitch (2) in…

Table of Contents General Information Resistance Check Check for Short Circuit from Pin to Pin General Information TOC The ECM can control a starter lockout…