Posted on by

Cummins N14 STC, Celect, Celect Plus – Service Manual 011-007   Exhaust Manifold, Dry

Table of Contents

Install

Install

 TOC

Install two guide studs.

Use an adhesive or heavy grease to hold the gaskets in place on the cylinder head.

NOTE: The side of the gasket marked “OUT”

must
be away from the cylinder heads.

SMALL | MEDIUM | LARGE


Special capscrews with spacers are required for this particular manifold.

Do

not
use short capscrews.

  
SMALL | MEDIUM | LARGE
   


 WARNING 

This component or assembly weighs greater than 23 kg [50 lb]. To prevent serious personal injury, be sure to have assistance or use appropriate lifting equipment to lift this component or assembly.

Install the exhaust manifold and ten capscrews.

Remove the guide studs, and install the remaining two capscrews.

NOTE: To aid in future capscrew removal, apply a film of high temperature anti-seize compound to the capscrew threads.

SMALL | MEDIUM | LARGE
   


Tighten the capscrews in the sequence shown.

Repeat the sequence and tighten the capscrews.

Torque Value:

  1. 47 n.m   
    [35 ft-lb]
  2. 81 n.m   
    [60 ft-lb]

SMALL | MEDIUM | LARGE
   


Install the turbocharger.

Refer to Procedure 010-033 in Section 10.

SMALL | MEDIUM | LARGE
   


Operate the engine and check for leaks and engine operation.

SMALL | MEDIUM | LARGE
Last Modified:  12-Sep-2011
Avatar photo

Published by Jack

Hello, I'm Jack, a diesel engine fan and a blogger. I write about how to fix and improve diesel engines, from cars to trucks to generators. I also review the newest models and innovations in the diesel market. If you are interested in learning more about diesel engines, check out my blog and leave your feedback.