Centinel System – Repair Manual – 001-028   Cylinder Liner

The cylinder liners can be removed by using either:

• Cylinder liner puller (universal), Part Number 3163745, and puller plate (S600), Part Number 3162462.
• Cylinder liner puller (universal), Part Number 3376015.

CAUTION  The cylinder puller must be installed and used as described to reduce the possibility of damage to the cylinder block. The puller plate must be parallel to the main bearing saddles and must not overlap the cylinder liner outside diameter.

Insert the cylinder liner puller onto the top of the cylinder block.

The cylinder liner puller must be centered on the top of the cylinder block.

Turn the puller jackscrew clockwise to loosen the cylinder liner from the cylinder block.

Use both hands to remove the cylinder liner.

Remove and discard the o-ring seals.

Use Dykem™, or equivalent, to place a mark on the intake air side of the cylinder liner to show cylinder liner orientation.

Use Dykem™, or equivalent, to mark the cylinder number on each cylinder liner.