Posted on by

Electronic Control System ISM and QSM11 Engines – 019-017   Engine Coolant Level Sensor

Table of Contents

Remove
Install

Remove

 TOC

 WARNING 

Do not remove the pressure cap from a hot engine. Wait until the coolant temperature is below 50°C [122°F] before removing the pressure cap. Heated coolant spray or steam can cause personal injury.

Remove the radiator cap.

Drain enough coolant from the cooling system to empty the radiator top tank. Refer to Procedure 008-018 in the ISM and QSM11 Engines Troubleshooting and Repair Manual, Bulletin 3666322.

SMALL | MEDIUM | LARGE


Lift up on the locking tab and pull the electrical connectors apart.

Remove the sensor.

SMALL | MEDIUM | LARGE
   

Install

 TOC

Install and tighten the new sensor according to the vehicle manufacturer’s procedures.

SMALL | MEDIUM | LARGE
   


Push the electrical connectors together until they lock.

Fill the cooling system and check for leaks. Refer to Procedure 008-018 in the ISM and QSM11 Engines Troubleshooting and Repair Manual, Bulletin 3666322.

SMALL | MEDIUM | LARGE
Last Modified:  28-Jan-2005
Avatar photo

Published by Jack

Hello, I'm Jack, a diesel engine fan and a blogger. I write about how to fix and improve diesel engines, from cars to trucks to generators. I also review the newest models and innovations in the diesel market. If you are interested in learning more about diesel engines, check out my blog and leave your feedback.