Posted on by

Electronic Control System Gas Plus Engines – 019-051   Fuse Holder

Table of Contents

Remove
Install

Remove

 TOC

Cut and remove the plastic hold down wire tie. Cut and remove the connector from the harness

SMALL | MEDIUM | LARGE


Remove about 6 mm [1/4 inch] of insulation from the supply wire.

SMALL | MEDIUM | LARGE
   

Install

 TOC

Install the replacement fuse holder, Part Number 3823758, on the bare wire.

SMALL | MEDIUM | LARGE
   


 CAUTION 

Only use wire crimping pliers, Part Number 3822930.

Crimp the repair wire on the bare wire.

Use a heat gun, Part Number 3823860, or an open flame to heat the shrink tubing. The tube will shrink and make the connection waterproof.

SMALL | MEDIUM | LARGE
Last Modified:  09-Aug-2004
Avatar photo

Published by Jack

Hello, I'm Jack, a diesel engine fan and a blogger. I write about how to fix and improve diesel engines, from cars to trucks to generators. I also review the newest models and innovations in the diesel market. If you are interested in learning more about diesel engines, check out my blog and leave your feedback.