Table of Contents Remove Install Remove TOC NOTE: For non-Cummins fan hub installations, contact the OEM. Loosen the fan idler pulley shaft locknut.   SMALL | MEDIUM | LARGE Next…

Table of Contents Adjust Remove Inspect for Reuse Install Adjust TOC Consult the vehicle manufacture for non-Cummins fan hub installations. Do not adjust belt tension…

Table of Contents Remove   Automatic Belt Tensioner Adjustment Link Type Install   Automatic Belt Tensioner Adjustment Link Type Adjust   Automatic Belt Tensioner Adjustment…

Table of Contents Remove Inspect for Reuse Install Remove TOC  WARNING  Do not remove the pressure cap from a hot engine. Wait until the coolant…

Table of Contents General Information Remove Install General Information TOC Belt drive systems equipped with an automatic belt tensioner can not be adjusted. A belt…

Table of Contents General Information General Information TOC The air starting motor system (tanks, line sizes, and valves) is designed and installed by the OEM…

Table of Contents Inspect Inspect TOC  CAUTION  The silicone fluid in the vibration damper will become solid after extended service and will make the damper…

Table of Contents Maintenance Check Maintenance Check TOC Measure the drive pulley flange end clearance at the correct maintenance interval in Section 2. Remove the…

Table of Contents Initial Check Initial Check TOC Remove the fan drive belt. Refer to Procedure 008-002 (Drive Belt, Cooling Fan) in Section A. Inspect…

Table of Contents Drain Clean Fill Drain TOC Position the vehicle on level ground.   SMALL | MEDIUM | LARGE Next  WARNING  Check the coolant level only when the…