Posted on by

Centinel System – Repair Manual – 003-011   Rocker Lever Cover

View Related Topic

Table of Contents

Install

Install

 TOC

NOTE: Engines built after September 7, 2006, or engines that have the cover gasket embedded in the rocker lever cover.

  • If the cover gasket was removed, install the cover gasket as soon as possible to avoid swelling of the cover gasket as the cover gasket swells due to its prior exposure to lubricating oil.
  • If a new cover gasket is required, use P80 lubriplate™, Part Number 3163086, or soapy water to lubricate the cover gasket.

If the cover gasket was removed or requires replacement, start the installation of the cover gasket at each bolt hole and press the cover gasket into the groove in the rocker level cover around each bolt hole.

After the cover gasket is in place around
all bolt holes, press the cover gasket into the grove of the rocker level cover starting from the bolt holes moving to the center of each span.

Inspect and make certain that there are no kinks, twists or other damage.

SMALL | MEDIUM | LARGE


Align the capscrew holes in the cylinder head to the cover gasket, and rocker lever cover prior to installing the capscrews and isolator assemblies.

Install the eight capscrews and isolator assemblies.

NOTE: Engines built before September 7, 2006, have the separate cover and a separate gasket, install the eight capscrews and isolator assemblies.

Tighten capscrews in sequence shown.

Torque Value:  25  n.m  [18 ft-lb]

SMALL | MEDIUM | LARGE
Last Modified:  31-Oct-2006
Avatar photo

Published by Jack

Hello, I'm Jack, a diesel engine fan and a blogger. I write about how to fix and improve diesel engines, from cars to trucks to generators. I also review the newest models and innovations in the diesel market. If you are interested in learning more about diesel engines, check out my blog and leave your feedback.