Posted on by

ISM, ISMe, and QSM11 – 012-017   Air Governor (Air Compressor Will Not Pump)

Table of Contents

Initial Check

Initial Check

 TOC

NOTE: The illustrations shown will be of the SS model single cylinder air compressor. Differences in procedures for Holset® models SS, QE, ST, and Cummins® air compressors will be shown where necessary.

Remove the air governor or air governor line from the air compressor unloader body.

SMALL | MEDIUM | LARGE


Operate the engine to activate the air compressor.

If the air compressor is pumping, the air governor is malfunctioning and must be repaired or replaced. Refer to the OEM service manual.

SMALL | MEDIUM | LARGE
   


If the air compressor does not pump, remove, clean, and inspect the air compressor unloader valve assembly. Refer to Procedure 012-013 in Section 12 and the Holset® Air Compressor Master Repair Manual, Bulletin 3666121.

If the unloader valve assembly is okay, clean and inspect the exhaust valve assembly. Refer to the Holset® Master Repair Manual, Bulletin 3666121.

NOTE: Not all air compressors referenced can be used on each engine or application

SMALL | MEDIUM | LARGE
Last Modified:  23-Jan-2009
Avatar photo

Published by Jack

Hello, I'm Jack, a diesel engine fan and a blogger. I write about how to fix and improve diesel engines, from cars to trucks to generators. I also review the newest models and innovations in the diesel market. If you are interested in learning more about diesel engines, check out my blog and leave your feedback.