1. If servicing a 2 wheel drive vehicle, install the engine mount assembly.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the engine mount assembly bolts, nuts, and washers to the crossmember.
Tighten
• Tighten the bolts to 59 N-m (44 Ib ft).
• Tighten the nuts to 45 N-m (33 Ib ft).
3. If servicing a 4 wheel drive vehicle, install the engine mount assembly.
4. Install the engine mount nuts, bolts, and washers to the crossmember.
Tighten
• Tighten the bolts to 59 N-m (44 Ib ft).
• Tighten the nuts to 45 N-m (33 Ib ft).
5. Remove the pole jack from the engine block.
6. Install the starter to the engine block (right side only). Refer to Starter Motor Replacement (Diesel, 6.5L) in Engine Electrical.
7. Lower the engine until the engine mount through bolt can be inserted.
8. Install the engine mount through bolt and the nut.
Tighten
Tighten the through bolt nut to 68 N-m (50 Ib ft).
9. Connect both the battery negative cables to the batteries. Refer to Battery Cable in Engine Electrical.
