1. Disconnect both the battery negative cable from the batteries. Refer to Battery Cable in Engine Electrical.
2. Raise the vehicle and support with safety stands.
3. Remove the starter from the engine block (right side only) and secure out of the way. Refer to Starter Motor Replacement (Diesel, 6.5L) in Engine Electrical.
4. Install a pole jack on the right rear comer of the engine block just above starter.
5. Remove the engine mount through bolt and the nut.
6. Raise the engine only enough to permit removal of the engine mount.
7. If servicing a 2 wheel drive vehicle, remove the engine mount assembly bolts, nuts, and washers.
8. Remove the engine mount assembly.
9. If servicing a 4 wheel drive vehicle, remove the engine mount assembly bolts, nuts, and washers.
10. Remove the engine mount assembly.
