1. If servicing a 2 wheel drive vehicle, install the engine mount assembly.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the engine mount assembly bolts, nuts, and washers.
Tighten
• Tighten the bolts to 59 N-m (44 Ib ft).
• Tighten the nuts to 45 N-m (33 Ib ft).
3. If servicing a 4 wheel drive vehicle, install the engine mount assembly.
Tighten
• Tighten the bolts to 59 N-m (44 Ib ft).
• Tighten the nuts to 45N-m (33 Ib ft).
4. Lower the engine until the engine mount through bolt can be inserted.
5. Install the engine mount through bolt and the nut.
Tighten
Tighten the through bolt nut to 68 N-m (50 Ib ft).
6. Remove the pole jack from the vehicle.
7. Connect both the battery negative cables to the batteries. Refer to Battery Cable in Engine Electrical.
