Centinel System – Repair Manual – 007-003   Lubricating Oil Cooler

WARNING  This component or assembly weighs greater than 23 kg [50 lb]. To prevent serious personal injury, be sure to have assistance or use appropriate lifting equipment to lift this component or assembly.

When installing a new two-element oil cooler on an older engine, be sure the cooler element mounting capscrews do
not interfere with the cylinder block.

Install the guide pins.

Remove the protective plugs from the oil passages. Make sure no debris enters the lubrication system. Using a clean shop towel, carefully wipe out the oil passages and inspect to make sure no debris is left in these passages.

Install a new mounting gasket and the oil cooler housing assembly.

Install the 18 capscrews.

Remove the guide pins and install the two capscrews.

Tighten the capscrews in a circular motion from the center out.