Table of Contents Remove Clean and Inspect for Reuse Install Remove TOC  WARNING  Do not remove the pressure cap from a hot engine. Wait until…

Table of Contents General Information Remove Install General Information TOC Belt drive systems equipped with an automatic belt tensioner can not be adjusted. A belt…

Table of Contents Remove   Automatic Belt Tensioner Adjustment Link Type Install   Automatic Belt Tensioner Adjustment Link Type Adjust   Automatic Belt Tensioner Adjustment…

Table of Contents Adjust Remove Inspect for Reuse Install Adjust TOC Consult the vehicle manufacture for non-Cummins fan hub installations. Do not adjust belt tension…

View Related Topic Table of Contents Remove   CELECT™ Plus STC Install   CELECT™ Plus STC Remove TOC CELECT™ Plus Disconnect the battery cables before…

Table of Contents Remove   CELECT™ or CELECT™ Plus STC Clean Inspect for Reuse Install   CELECT™ or CELECT™ Plus STC Prime   General Information…

Table of Contents Inspect for Reuse Inspect for Reuse TOC To start a STC engine in case of an electrical failure, turn the knob on…

Table of Contents Initial Check Initial Check TOC NOTE: The illustrations shown are of the SS model single-cylinder air compressor. Differences in procedures between the other…

Table of Contents Maintenance Check Maintenance Check TOC Measure the drive pulley flange end clearance at the correct maintenance interval in Section 2. Remove the…

Table of Contents Initial Check Initial Check TOC Remove the fan drive belt. Refer to Procedure 008-002 (Drive Belt, Cooling Fan) in Section A. Inspect…