1. Remove the camshaft sprocket retaining bolt and washer. 2. Remove the fuel injection pump drive gear. Important: Do not damage the square bosses of…

Tools Required J 7872 Magnetic Base Dial Indicator 1. Attach the J 7872 to the front of the engine cylinder block. • Position the magnetic…

1. Remove the oil pan to front cover retaining bolts. 2. Remove the front cover to block retaining bolts. Notice: Perform TDC Offset Recovery procedure…

Tools Required J 39046 Crankshaft Balancer Remover 1. Remove the crank shaft pulley retaining bolts. 2. Remove the crankshaft pulley. 3. Remove the crankshaft balancer…

Tools Required • J 29873 Nozzle Socket • J 29698-B Fuel Line Wrench, 3 /4 inch Notice: The fuel injection pump is an electronically controlled…

1. Remove the thermostat bypass fitting. Important: The water pump bolts to the water pump plate from the back. Remove the water pump and water…

1. Remove the left side exhaust manifold bolts. 2. Remove the left side exhaust manifold. 3. Remove the right side exhaust manifold bolts. 4. Remove…

1. Remove the oil pump drive clam retaining bolt. 2. Remove the oil pump drive clamp. 3. Remove the oil pump drive. 4. Remove the…

1. Loosen the Crankcase Depression Regulator (CDR) valve vent hose clamp at the CDR valve. 2. Remove the CDR valve vent hose (3) from the…

Tools Required • J 41515-A Glow Plug Socket • J 41712 Oil Pressure Sending Unit Socket 1. Disconnect all engine wiring harness connectors. 2. Disconnect…