The cranking system has the the following parts (refer to Figure 8-7): • Connection to battery power • The ignition switch and wiring • A…

The vehicle electrical systems use two 12-volt batteries connected in parallel to provide a cold cranking current of 1140 amperes at 0° F (-18° C).…

The engine block heater mounts in the middle coolant passage bore of the left side of the cylinder case (see Figure 8-2, view A). It…

The electrical systems of the 6.5L V8 turbo diesel engine include the following groups of parts (refer to Figure 8-1): • Block heater system •…

1. Bring the engine to a temperature of 80° F (27° C). 2. If available, install a diesel injection timing meter (J 33300). 3. Start…

1. Remove the electrical connector for the fuel shut-off solenoid from the injection pump. 2. Move the ignition switch to the RUN position. 3. Momentarily…

1. Bring the engine to operating temperature. 2. Set the parking brake and block the drive wheels. 3. Turn off all accessories. 4. Install a…

1. Bring the engine to operating temperature, with all glow plugs operating correctly. 2. With the engine running, do the following things: • Disconnect the…

1. Check fuel injection pump static timing: • Align the front cover and injection pump marks. 2. Check low idle speed (refer to page 7-87…

1. Bring the engine to operating temperature. 2. If available, install a diesel injection timing meter (J 33300). 3. Remove the intake manifold upper cover…