019-197   Ring Terminal

Table of Contents

Connector Replacement

Connector Replacement

TOC

Terminals are used on the engine harness for various connections including grounds and fuel shutoff valve supply.

 
SMALL | MEDIUM | LARGE


Use wire crimp tool, Part Number 3822930, to cut and remove the ring terminal connector as shown.

SMALL | MEDIUM | LARGE
   


Use wire crimp tool, Part Number 3822930, to remove 6 mm [1/4 in] of insulation from the harness wire.

SMALL | MEDIUM | LARGE
   


Install the proper-size ring terminal on the bare wire. The ring terminals that are included in the wiring repair kit, Part Number 3164572, are as follows:

Ring Terminal Size Part No.
No. 10 3823760
1/2 inch 3823761

SMALL | MEDIUM | LARGE
   


 CAUTION 

Only use wire crimping pliers, Part Number 3822930, when repairing electrical terminals.

Crimp the repair wire on the bare wire.

Use a heat gun, Part Number 3822860, or open flame to heat the shrink tubing. The tubing will shrink and make the connection waterproof.

SMALL | MEDIUM | LARGE
Last Modified:  03-Apr-2003

Leave a Reply

Your email address will not be published. Required fields are marked *