Posted on by

M11 Series – Service Manual – 005-060   Fuel Pump Pressure Regulator

Table of Contents

Initial Check

Initial Check

 TOC

To check for a sticking pressure regulator, install a pressure gauge on the Compuchek® fitting in the side of the fuel shutoff valve.

Start cranking the engine.

The pressure gauge

must start moving immediately and increase rapidly until the engine fires (approximately 172 kPa [25 psi]). This should take 3 to 5 seconds.

SMALL | MEDIUM | LARGE


If the pressure gauge does

not move or increases very slowly for more than 6 seconds, the regulator plunger is stuck open and will

not let pressure build up quickly for a normal start. This can be caused by dirt, rust, or burrs on the plunger, or burrs on the plunger bore.

If the plunger is sticking, the gear pump

must be replaced with a new or ReCon® unit.

Refer to the Engine Shop Manual, Bulletin No. 3666075.

SMALL | MEDIUM | LARGE
Last Modified:  07-May-2003
Avatar photo

Published by Jack

Hello, I'm Jack, a diesel engine fan and a blogger. I write about how to fix and improve diesel engines, from cars to trucks to generators. I also review the newest models and innovations in the diesel market. If you are interested in learning more about diesel engines, check out my blog and leave your feedback.