N14 Base Engine Troubleshooting and Repair Manual – 008-016   Coolant Thermostat Seal

Remove

TOC

NOTE: The N14 CELECT™ and CELECT™ Plus engines has one engine coolant thermostat and one aftercooler thermostat. The N14 STC engines have two engine thermostats and no aftercooler thermostat. The artwork in this procedure reflects the N14 CELECT™ engine but is representative of all the engines.

Remove the thermostat seal. Do

not damage the thermostat cover.

SMALL | MEDIUM | LARGE

Clean

TOC

Clean and inspect the thermostat housing for cracks, pitting, or other damage.

Replace if damage is found.

SMALL | MEDIUM | LARGE
   

Inspect for Reuse

TOC

NOTE: The N14 CELECT™ and CELECT™ Plus engines has one engine coolant thermostat and one aftercooler thermostat. The N14 STC engines have two engine thermostats and no aftercooler thermostat. The artwork in this procedure reflects the N14 CELECT™ engine but is representative of all the engines.

Visually inspect the thermostat seal for cracks, corrosion, or other damage. Replace if necessary.

SMALL | MEDIUM | LARGE
   

Install

TOC

NOTE: The N14 CELECT™ and CELECT™ Plus engines has one engine coolant thermostat and one aftercooler thermostat. The N14 STC engines have two engine thermostats and no aftercooler thermostat. The artwork in this procedure reflects the N14 CELECT™ engine but is representative of all the engines.

 CAUTION 

When installing a new seal, the flat side of the seal must be toward the mandrel for correct installation.

Use thermostat seal mandrel, Part No. ST-1225, and a lead hammer to install the seal.

A counterbore in the housing bore locates the seal.

SMALL | MEDIUM | LARGE
Last Modified:  12-May-2003