Symptom Tree t072
| Cause | Correction |
|---|
|
Electronic fault codes active or high counts of inactive fault codes |
Refer to Section TF in the Troubleshooting and Repair Manual CELECT™ Plus Systems, Bulletin 3666130, or Section TF in the Troubleshooting and Repair Manual for CELECT™ Systems, Bulletin 3666084. |
 |
|
Fuel level is low in the tank |
Fill the supply tank. Refer to the OEM vehicle specifications. |
|
|
Engine idle speed is set too low (mechanical fuel systems) |
Adjust the fuel pump idle speed. Refer to Procedure 005-029. |
|
|
Idle shutdown or PTO shutdown features are activated |
Turn OFF the keyswitch for 5 seconds. Turn ON the keyswitch and check fault lamp operation. |
|
|
Air in the fuel system |
Check for air in the fuel system. Refer to Procedure 006-003. |
|
|
Engine-driven units are engaged |
Disengage engine-driven units. |
|
|
Fuel is waxing due to cold weather |
Check the fuel heater, if installed. Weather conditions sometimes require a fuel heater. |
|
|
Fuel inlet restriction |
Check for fuel inlet restriction. Refer to Procedure 006-020. |
|
|
Fuel shutoff valve (FSOV) is closed |
Check the fuel shutoff valve and the electrical circuit. Refer to Procedure 019-050 in the Troubleshooting and Repair Manual CELECT™ Plus Systems, Bulletin 3666130, or Section TF in the Troubleshooting and Repair Manual for CELECT™ Systems, Bulletin 3666084. |
|
|
Exhaust system restriction |
Check the exhaust system for any restrictions. Refer to Procedure 011-009. |
|
|
Air intake system restriction |
Check the air intake system for restriction. Refer to Procedure 010-031. |
|
|
Fuel grade is not correct for the application or the fuel quality is poor |
Operate the engine from a tank of high-quality fuel. Refer to Fuel for Cummins Engines, Bulletin 3379001. |
|
|
Fuel pump is malfunctioning |
Check the fuel pump output pressure with INSITE™, an electronic service tool. Replace the fuel pump if necessary. Refer to Procedure 005-016. |
|
|
Engine brake adjustment is not correct |
Adjust the engine brakes. Refer to Procedure 020-001. |
|
|
Injector cup spray holes are plugged |
Remove and clean the injectors. Refer to Procedure 006-026. |
|
|
Static injection timing is not correct |
Check the static injection timing. Refer to Procedure 006-025. |
