Posted on by

B5.9G, B5.9LPG – Troubleshooting and Repair Manual – 010-047   Turbocharger Radial Bearing Clearance

Table of Contents

Measure

Measure

 TOC

Remove the intake and exhaust pipes from the turbocharger.

SMALL | MEDIUM | LARGE


Use a narrow blade or a wire-type feeler gauge to measure the clearance between the compressor wheel and housing.

Gently push the compressor wheel toward the compressor housing and gauge.

Record this clearance.

SMALL | MEDIUM | LARGE
   


With the feeler gauge in the same location, gently push the compressor wheel away from the compressor housing, and measure the clearance between the compressor wheel and housing.

Record this clearance.

SMALL | MEDIUM | LARGE
   


Subtract the smaller clearance from the larger clearance. This is the radial bearing clearance.

Radial Bearing Clearance
mm in
0.30 MIN 0.012
0.46 MAX 0.018

Replace the turbocharger if the radial bearing clearance does not meet the specifications. Refer to Procedure 010-033 for the replacement procedure.

SMALL | MEDIUM | LARGE
   


Install the intake pipe, and tighten the clamp.

Install the exhaust pipe, and tighten the clamp.

Torque Value:  8  n.m  [71 in-lb]

SMALL | MEDIUM | LARGE
Last Modified:  27-Jun-2002
Avatar photo

Published by Jack

Hello, I'm Jack, a diesel engine fan and a blogger. I write about how to fix and improve diesel engines, from cars to trucks to generators. I also review the newest models and innovations in the diesel market. If you are interested in learning more about diesel engines, check out my blog and leave your feedback.