Centinel System – Repair Manual – 009-055   Refrigerant Compressor Mounting Bracket

WARNING  To protect the environment, liquid refrigerant systems must be properly emptied and filled using equipment that prevents the release of refrigerant gas into the atmosphere. Federal law requires capturing and recycling the refrigerant.

• Remove the cooling fan drive belt. Refer to Procedure 008-002.
• Remove the refrigerant compressor belt. Refer to Procedure 009-052.
• Remove the refrigerant compressor. Refer to Procedure 009-051.

WARNING  To protect the environment, liquid refrigerant systems must be properly emptied and filled using equipment that prevents the release of refrigerant gas into the atmosphere. Federal law requires capturing and recycling the refrigerant.

• Remove the refrigerant compressor and alternator belt. Refer to Procedure 013-005.
• Remove the refrigerant compressor. Refer to Procedure 009-051.

Remove the mounting capscrew from each refrigerant compressor bracket.

Remove the refrigerant compressor brackets.

Remove the four mounting capscrews from the refrigerant compressor bracket.

Remove the refrigerant compressor bracket from the refrigerant compressor.

Remove the two bracket mounting capscrews and the bracket.

Remove the support links from the bracket.

WARNING  When using solvents, acids, or alkaline materials for cleaning, follow the manufacturer’s recommendations for use. Wear goggles and protect clothing to reduce the possibility of personal injury.

WARNING  Wear appropriate eye and face protection when using compressed air. Flying debris and dirt can cause personal injury.

Clean the refrigerant compressor mounting brackets with solvents.

Dry with compressed air.

Inspect the refrigerant compressor mounting brackets.

Replace the refrigerant compressor mounting brackets if cracked or damaged.

Inspect the roll pins. The roll pins must not be loose or have any damage. Replace the refrigerant compressor mounting brackets, if the roll pins are loose or damaged.

WARNING  When using solvents, acids, or alkaline materials for cleaning, follow the manufacturer’s recommendations for use. Wear goggles and protective clothing to reduce the possibility of personal injury.

WARNING  Wear appropriate eye and face protection when using compressed air. Flying debris and dirt can cause personal injury.

Clean the bracket, links, and mounting capscrews with solvent.

Dry the parts with compressed air.

Inspect the bracket and links for cracks.

Replace the bracket or links if damage is found.

Install the two mounting capscrews and the refrigerant compressor mounting bracket.

Tighten the capscrews.

Install the refrigerant compressor mounting bracket to the refrigerant compressor. The refrigerant compressor is positioned on top of the bracket ledge.

Install the four mounting capscrews and the refrigerant compressor bracket.

Tighten the capscrews.

Before installation, inspect the refrigerant compressor bracket to make sure the mounting spacers are installed properly.

Install the refrigerant compressor bracket on the gear housing with two long capscrews.

Tighten the capscrews.

Position both links in the assembly with the part number facing outward.

Insert one capscrew through the elongated hole in the long link and attach the long link to the left side of the refrigerant compressor bracket.

Insert one capscrew through the small hole in the short link and attach the short link to the right side of the refrigerant compressor bracket.

• Install the refrigerant compressor. Refer to Procedure 009-051.
• Install the refrigerant compressor belt. Refer to Procedure 009-052.
• Install the fan drive belt. Refer to Procedure 008-002.

• Install the refrigerant compressor. Refer to Procedure 009-051.
• Install the refrigerant compressor and alternator belt. Refer to Procedure 013-005.