Centinel System – Repair Manual – 013-036   Alternator Spacer

Preparatory Steps

TOC

Remove the following:

  • Cooling fan drive belt. Refer to Procedure 008-002.
  • Alternator. Refer to Procedure 013-001.
 
SMALL | MEDIUM | LARGE

Remove

TOC

Remove the two alternator spacer mounting capscrews.

Remove the alternator spacers.

SMALL | MEDIUM | LARGE
   

Clean and Inspect for Reuse

TOC

 WARNING 

When using solvents, acids, or alkaline materials for cleaning, follow the manufacturer’s recommendations for use. Wear goggles and protective clothing to reduce the possibility of personal injury.
 WARNING 

Some solvents are flammable and toxic. Read the manufacturer’s instructions before using.
 WARNING 

Wear appropriate eye and face protection when using compressed air. Flying debris and dirt can cause personal injury.

Clean the alternator spacers with solvents.

Dry with compressed air.

SMALL | MEDIUM | LARGE
   


Inspect the alternator spacers for cracks. Replace the spacers if cracks are found.

Inspect the roll pins. The roll pins must not be loose or have any damage. Replace the alternators spacers if the roll pins are loose or damaged.

SMALL | MEDIUM | LARGE
   

Install

TOC

NOTE: No special alignment process is required for alternator spacers to the alternator/refrigerant compressor mounting bracket.

Install the alternator spacers with roll pins and two capscrews.

Torque Value:  36  n.m  [27 ft-lb]

SMALL | MEDIUM | LARGE
   

Finishing Steps

TOC

Install the following:

  • Alternator. Refer to Procedure 013-001.
  • Cooling fan drive belt. Refer to Procedure 008-002.
 
SMALL | MEDIUM | LARGE
Last Modified:  19-Dec-2002