Posted on by

Electronic Control System ISM and QSM11 Engines – 019-061   Intake Manifold Pressure Sensor

Table of Contents

General Information
 

Remove
Install
 

General Information

 TOC


The intake manifold air pressure (1) and intake manifold air temperature (2) is located on the top front half of the intake manifold. The ECM uses this information for the engine protection system.

  
SMALL | MEDIUM | LARGE

Remove

 TOC

Lift up on the tab and disconnect the connector from the sensor.

Remove the sensor from the air intake manifold with deep flank drive socket, Part No. 3823843.

SMALL | MEDIUM | LARGE
   

Install

 TOC


Make sure the new sensor has an o-ring around the surface where it seals against the air intake manifold.

Install the sensor into the air intake manifold by turning it clockwise.

Torque Value:  14  n.m  [124 in-lb]

SMALL | MEDIUM | LARGE
   


Push the harness connector into the sensor until it locks.

SMALL | MEDIUM | LARGE
Last Modified:  03-Jun-2002
Avatar photo

Published by Jack

Hello, I'm Jack, a diesel engine fan and a blogger. I write about how to fix and improve diesel engines, from cars to trucks to generators. I also review the newest models and innovations in the diesel market. If you are interested in learning more about diesel engines, check out my blog and leave your feedback.