CM850 Electronic Control System – FAULT CODE 151 (ISB/QSB Automotive and Industrial, ISC/QSC/ISL/QSL Automotive, Industrial, and Marine)

Engine Coolant Temperature – Data Valid but Above Normal Operational Range – Most Severe Level


Overview

CODE REASON EFFECT
Fault Code: 151
PID: P110
SPN: 110
FMI: 0/0
LAMP: Red
SRT: 

Engine Coolant Temperature – Data Valid but Above Normal Operational Range – Most Severe Level. Engine coolant temperature signal indicates engine coolant temperature above engine protection critical limit.

Automotive: Progressive power derate increasing in severity from time of alert. If Engine Protection Shutdown feature is enabled, engine will shut down 30 seconds after red Stop lamp starts flashing.

Marine:
calibration dependent.

Coolant Temperature Sensor Circuit
SMALL | MEDIUM | LARGE

Circuit Description

The engine coolant temperature sensor is used by the electronic control module (ECM) to monitor the engine coolant temperature. The ECM monitors the voltage on the signal pin and converts this to a temperature value. The engine coolant temperature value is used by the ECM for the engine protection system and engine emission control.

Component Location

The engine coolant temperature sensor is located on the thermostat housing. Refer to Procedure 100-002 for a detailed component location view.

Shop Talk

This fault code indicates that coolant temperature has exceeded the engine protection limits for high coolant temperature. Refer to the Engine Coolant Temperature Above Normal symptom troubleshooting tree in Troubleshooting and Repair Manual, ISC, QSC8.3, ISL and QSL9 Engines, Bulletin 4021418 or ISBe and ISB (Common Rail Fuel System) Series Engines, Bulletin 4021271.

Refer to Troubleshooting Fault Code t05-151

Last Modified:  08-Jul-2010