Engine Misfire Cylinder 3 – Condition Exists.
|
Overview
CODE | REASON | EFFECT |
Fault Code: 1656 PID: SPN: 1325 FMI: 11/31 LAMP: Amber SRT: |
Engine Misfire Cylinder 3 – Condition Exists. Engine misfire has been detected in cylinder number 3. |
Possible low power, rough idle, or misfire. |
Circuit
|
Circuit Description
An algorithm in the ECM calibration monitors engine speed as each injector fires while the engine is at idle. If a cylinder has high or low contribution to engine speed, this fault will become active. The intention of this fault is to assist in troubleshooting performance complaints such as engine misfire and low power.
Component Location
The ECM is located on the intake side of the engine. Refer to Procedure 100-002 (Engine Diagrams) in Section E for a detailed component location view.
Shop Talk
If Fault Code 1656 is inactive in the ECM memory and there is no complaint such as “low power” or “engine misfire”, it is possible that an intermittent event such as air entering the fuel system following a filter change caused the fault. Inactive counts of Fault Code 1656 should be disregarded unless other performance symptoms are present. The engine coolant temperature must be greater than 71°C [160°F] before this diagnostic will run.
Causes of cylinder misfire can include:
- Valve lash out of specification (compare actual valve lash to reset limits)
- Cylinder failure (check for high blowby when the engine is loaded)
- Valve failure or valve held open (listen for intake valve “chirping” noise in the intake)
- Cylinder head or gasket failure (look for signs of oil, coolant, or casting flash in the intake or exhaust passages)
- Extreme camshaft wear (inspect the camshaft lobes for wear)
- Extra, missing, or damaged sealing washer under an injector
- Injector failures (“swap” injectors to see if the problem “follows” the indicated injector).
- Check air compressor timing (if engine has had fault since new or has had a recent air compressor replacement.)
- For 6 cylinder ISBe4 automatic transmission applications: Check “On-Board Diagnostic (OBD) misfire alternate gains” setting in the features and parameters screen in INSITE™ electronic service tool. If the vehicle is fitted with a Voith transmission, this should be set to 2. All others are set to 1.
On-Board Diagnostic Information:
- The ECM illuminates the malfunction indicator lamp (MIL) when the diagnostic runs and fails
- The ECM turns OFF the MIL after 3 consecutive ignition cycles, with the engine running for at least 10 seconds, that the diagnostic runs and does not fail. The MIL lamp and fault code can also be cleared, use the INSITE™ electronic service tool
- The fault code will be cleared from the memory after 40 consecutive drive cycles when the diagnostic runs and passes.
Refer to Troubleshooting Fault Code t05-1656