ISC, ISCe, QSC8.3, ISL, ISLe3, ISLe4 and QSL9 Engines – 007-009   Lubricating Oil Dipstick

Table of Contents

Calibrate

Calibrate

TOC

 WARNING 

Some state and federal agencies have determined that used engine oil can be carcinogenic and can cause reproductive toxicity. Avoid inhalation of vapors, ingestion, and prolonged contact with used engine oil. If not reused, dispose of in accordance with local environmental regulations.
 WARNING 

To reduce the possibility of personal injury, avoid direct contact of hot oil with your skin.

Drain the lubricating oil. Refer to Procedure 007-037 in Section 7.

Install the dipstick in the dipstick tube housing.

Use clean lubricating oil to fill the oil pan to the specified LOW oil level. Refer to Procedure 018-017 in Section V.

SMALL | MEDIUM | LARGE


 CAUTION 

Use care when marking the dipstick. The dipstick will break if the scribe mark is too deep.

Remove the dipstick and scribe a mark across the stick at the oil level. Label the mark with an L to indicate the “LOW” oil level.

NOTE: If a new blank dipstick is being used, cut the dipstick off approximately 38 mm [1.5 in] below the LOW oil level mark.

SMALL | MEDIUM | LARGE
   


Wipe off the dipstick and install it in the dipstick tube housing.

Use clean lubricating oil to fill the oil pan to the specified HIGH oil level. Refer to Procedure 018-017 in Section V.

SMALL | MEDIUM | LARGE
   


 CAUTION 

Use care when marking the dipstick. The dipstick will break if the scribe mark is too deep.

Remove the dipstick and scribe a mark across the stick at the oil level. Label the mark with an H to indicate the HIGH oil level.

SMALL | MEDIUM | LARGE
Last Modified:  24-Sep-2009