Posted on by

ISC, ISCe, QSC8.3, ISL, ISLe3, ISLe4 and QSL9 Engines – 011-037   Exhaust Gas Temperature Sensor

Remove

 TOC

Slide the locking tab on the top side of the connector to the unlock position.

Press down on the tab near the end of the harness connector where the harness wires lead into the connector.

Pull outward on the connector away from the sensor to disconnect.

SMALL | MEDIUM | LARGE


Remove the sensor from the mounting boss in the exhaust piping.

SMALL | MEDIUM | LARGE
   

Clean and Inspect for Reuse

 TOC

Inspect for damaged or exposed wires, bent or broken pins, damaged connectors, or damaged threads.

Replace if any damage is found.

SMALL | MEDIUM | LARGE
   

Install

 TOC

Put a light coating of anti-seize on the exhaust gas temperature sensor mounting threads.

Install the sensor into the mounting boss in the exhaust piping.

Tighten the sensor.

Torque Value:  30  n.m  [22 ft-lb]

Push the connectors together until they lock.

Slide the locking tab to the lock position.

Reset the exhaust gas treatment monitor unit. Refer to Procedure 011-035.

SMALL | MEDIUM | LARGE
Last Modified:  28-Mar-2007
Avatar photo

Published by Jack

Hello, I'm Jack, a diesel engine fan and a blogger. I write about how to fix and improve diesel engines, from cars to trucks to generators. I also review the newest models and innovations in the diesel market. If you are interested in learning more about diesel engines, check out my blog and leave your feedback.