CM2150 Electronic Control System – 019-008   Battery Ground Circuit

Table of Contents

Voltage Check

Voltage Check


Check the power harness ground connection for loose, corroded, or broken connections.



The leads must fit tightly in the connector without expanding the pins in the connector otherwise the connector will be damaged.

Insert the lead into the electronic control module (ECM) battery supply negative (-) of the ECM power harness connector. Connect the alligator clip to the multimeter probe. Touch the other multimeter probe to the engine block ground and measure the resistance. The resistance
must be 10 ohms or less.


If the resistance value is
not correct, check the batteries, cables, and cable connections.

Repair or replace the parts as required.

Last Modified:  30-May-2008