Cummins N14 STC, Celect, Celect Plus – Service Manual 005-038   Fuel Pump VS Throttle Shaft Housing

Table of Contents

Remove
Install

Remove

TOC

Mark the angle of the VS throttle lever on the VS throttle shaft. Remove the VS throttle lever.

SMALL | MEDIUM | LARGE


NOTE: Make sure the components in the spring pack guide do

not
fall out when the cover is removed.

Remove the VS spring pack housing cover.

SMALL | MEDIUM | LARGE
   


Loosen the set screw in the VS throttle stop.

SMALL | MEDIUM | LARGE
   


Remove the VS throttle shaft from the cover. Discard the o-rings.

Remove the shaft dust seals from the cover and discard.

SMALL | MEDIUM | LARGE
   


If fuel is leaking between the bushings and the cover, replace the bushings.

  • Press the bushings from the cover

SMALL | MEDIUM | LARGE
   


  • Install the new bushings into the cover

SMALL | MEDIUM | LARGE
   


Examine the o-ring for excessive wear.

If the o-ring wear is due to inadequate surface finish in the throttle shaft o-ring groove, replace the throttle shaft.

NOTE: Before installing the new shaft, mark the end of the new shaft in the same location as the mark on the old shaft to allow correct alignment of the VS throttle lever.

SMALL | MEDIUM | LARGE
   

Install

TOC

Install new dust seals into the cover.

Install an o-ring on the shaft near the lever end.

Apply clean vegetable oil to the o-ring before installation.

SMALL | MEDIUM | LARGE
   


Place the throttle stop into the cover.

NOTE: The longest lever on the stop goes toward the rear adjustment screw.

Install the shaft into the cover and through the stop.

SMALL | MEDIUM | LARGE
   


Push the shaft out of the other side of the cover.

Install the other shaft o-ring and apply clean vegetable oil to the o-ring before installation.

Push the shaft back into the cover.

SMALL | MEDIUM | LARGE
   


Align the setscrew hole in the stop with the hole in the shaft.

Install the setscrew into the stop and tighten.

Torque Value:  7  n.m  [60 in-lb]

SMALL | MEDIUM | LARGE
   


Assemble the cover to the fuel pump with a new gasket.

SMALL | MEDIUM | LARGE
   


Align the lever with the mark on the throttle shaft to install the lever.

Tighten the lever retaining nut to secure the lever to the shaft.

Check the throttle linkage for binding.

SMALL | MEDIUM | LARGE
Last Modified:  12-May-2003