Posted on by

Cummins N14 STC, Celect, Celect Plus – Service Manual 007-010   Lubricating Oil Dipstick Housing

Remove

 TOC

Remove the four capscrews and housing.

SMALL | MEDIUM | LARGE

Clean and Inspect for Reuse

 TOC

Remove all gasket material from the cylinder block gasket surface.

NOTE: Do not cut the gasket mounting surface with the scraper.

Use solvent to clean the dipstick, dipstick tube, and the housing gasket surface.

Dry with compressed air.

SMALL | MEDIUM | LARGE
   


Inspect the dipstick guide tube for cracks or other damage.

NOTE: If the guide tube is cracked, missing, or

not
angled downward in the oil pan, replace the dipstick tube housing.

SMALL | MEDIUM | LARGE
   

Install

 TOC

Install the dipstick tube housing and a new gasket.

Install the four capscrews and tighten.

Torque Value:  47  n.m  [35 ft-lb]

NOTE: Check the dipstick calibration.

Refer to Procedure 007-009 in Section 7.

SMALL | MEDIUM | LARGE
Last Modified:  12-Sep-2011
Avatar photo

Published by Jack

Hello, I'm Jack, a diesel engine fan and a blogger. I write about how to fix and improve diesel engines, from cars to trucks to generators. I also review the newest models and innovations in the diesel market. If you are interested in learning more about diesel engines, check out my blog and leave your feedback.