Posted on by

Cummins N14 STC, Celect, Celect Plus – Service Manual 007-037   Lubricating Oil System

Table of Contents

Fill

Fill

 TOC

Install the oil drain plug and tighten.

Torque Value:  88  n.m  [65 ft-lb]

Add the specified amount of 36 liters [9.5 gal] of clean 15W-40 oil to fill the oil pan.

SMALL | MEDIUM | LARGE


Check the oil level on the dipstick. It must be filled to the “H” (high) mark. Use the following procedure for dipstick calibration. Refer to Procedure 007-009 in Section 7.

Operate the engine until the water temperature reaches 82°C [180°F], and check for leaks.

SMALL | MEDIUM | LARGE
   


Shut the engine OFF. Wait 5 to 7 minutes for the oil to drain back to the oil pan.

Check the oil level. Add oil as necessary to bring the level up to the “H” (high) mark on the dipstick.

SMALL | MEDIUM | LARGE
Last Modified:  03-Oct-2011
Avatar photo

Published by Jack

Hello, I'm Jack, a diesel engine fan and a blogger. I write about how to fix and improve diesel engines, from cars to trucks to generators. I also review the newest models and innovations in the diesel market. If you are interested in learning more about diesel engines, check out my blog and leave your feedback.