Tools Required
J 39084 Crankshaft Rear Oil Seal Installer
1. Use the J 39084 to install the crankshaft rear oil seal to the crankshaft.
2. Install the flywheel to the crankshaft. Refer to Engine Flywheel Replacement.
3. Install the clutch assembly to the crankshaft (if equipped). Refer to Clutch Assembly Replacement in Transmission/Transaxle.
4. Install the transmission (2 wheel drive models only) to the vehicle.
• F or the 4L80-E automatic transmission, refer to Transmission Replacement in Transmission /Transaxle
• F or the NV 4500 manual transmission, refer to Transmission Replacement in Transmission /Transaxle.
5. Install the flywheel inspection cover if needed.
6. Install the transfer case (4 wheel drive mode ls only).
• For the BW 4401, BW 4470, and NVG 241-NP 2 transfer cases, refer to Transfer Case Replacement in Driveline/Axle.
• For the NVG 243-NP 1 transfer case, refer to Transfer Case Replacement in Driveline/Axle.
• For the NVG 246 -NP 8 transfer case, refer to Transfer Case Replacement in Driveline/Axle.
7. Install the front propeller shaft (4 wheel drive models only). Refer to.
• For vehicle equipped with the non active transfer case, refer to Propeller Shaft Replacement (Front Axle – All Except NP8) in Transmission/Transaxle.
• For vehicle equipped with the active transfer case, refer to Propeller Shaft Replacement (Front Axle – NP8) in Transmission/Transaxle.
8. Lower the vehicle.
9. Install the oil level indictor and tube to the engine block. Refer to Oil Level Indicator and Tube Replacement.
10. Connect both the battery negative cables to the batteries. Refer to Battery Cable in Engine Electrical.
