Table of Contents Preparatory Steps Remove Clean and Inspect for Reuse Install Measure   Bore Runout Face Runout Finishing Steps Preparatory Steps TOC  WARNING  This…

Table of Contents Remove Clean and Inspect for Reuse Install Remove TOC Use a hoist or lifting fixture to support the front of the engine.…

Table of Contents Remove Clean and Inspect for Reuse Install Remove TOC Remove the capscrews and the front lifting bracket. Remove the capscrews and the…

Mounting Adaptations Tool Number ST-1325 Dial Gauge Attachment Attaches to crankshaft flange to provide measuring of flywheel and flywheel housing runout with dial bore gauge.…

Table of Contents General Information Preparatory Steps Setup Test Finishing Steps General Information TOC The Snap-Acceleration Test is used to check the aftertreatment diesel particulate…

Table of Contents General Information Initial Check Measure General Information TOC NOTE: Some illustrations in this procedure do not show actual engine configurations. The procedure, however,…

Table of Contents General Information General Information TOC When it is not possible to load an engine immediately after rebuild or repair (for example, on-highway…

Table of Contents Setup Setup TOC The Setup for Dynamometer function is used to prepare the engine ECM for an advanced diagnostic test run on…

Table of Contents Run-In Instructions Run-In Instructions TOC Follow the general operating procedures and safety precautions when performing the engine run-in. Refer to Procedure 014-005…

Table of Contents Setup   Coolant Plumbing Intake Air Temperature Control Air Compressor Starting Motor Engine Throttle Control Test   Engine Speed (rpm) Fuel Rate…