Symptom Tree t104 Printable Version This is symptom tree Cause Correction Electronic fault codes active or high counts of inactive fault codes Refer to Section TF…
Notice: Do not allow the RTV sealant into the valve rocker arm cover bolt holes. This may cause a “valve lock” condition, when the bolts…
1. Disconnect both the battery negative cables from the batteries. Refer to Battery Cable in Engine Electrical. 2. Remove the CDR valve from the valve…
Important: Always replace existing O-ring when installing the oil level indicator tub e . 1. Apply a small a mount of clean engine oil on…
1. Remove the oil level indicator from the oil level indicator tube. 2. Remove the oil level indicator tube mounting bolt. 3. Remove the left…
Important: When replacing the oil pump drive gear, always use a new O-ring. 1. Coat the n ew O -ring with clean engine oil before…
Notice: Do not run the engine without the oil pump drive in place. This will cause extensive engine damage. 1. Remove the engine cover from…
Tools Required J 41712 Oil P r e s s u r e S e n d in g Unit S o c k e…
Tools Required J 41712 Oil Pressure Sending Unit Socket 1. Remove the engine cover from the engine block. 2. Remove the fuel filter/water separator from…
Important: Be sure to use the correct gasket. The gasket for the L 56 mode ls have openings for the EGR Valve, the gaskets for…