Posted on by

Cummins N14 STC, Celect, Celect Plus – Service Manual 019-081   Sensor Wiring Harness

Table of Contents

Install

Install

 TOC

Install the sensor harness to the engine.

SMALL | MEDIUM | LARGE


Install the sensor harness AMP connector to the ECM.

Tighten the connector capscrews to the ECM.

Torque Value:  2  n.m  [18 in-lb]

SMALL | MEDIUM | LARGE
   


Install the sensor wiring harness retaining clamps to the support bracket and the engine block.

Torque Value:  20  n.m  [177 in-lb]

SMALL | MEDIUM | LARGE
   


Install the mounting hardware and connect the following sensors to the sensor harness:

  • Oil pressure sensor
  • Oil temperature sensor
  • Ambient air pressure
  • Fuel shutoff control wire
  • Engine position sensor
  • Engine coolant temperature sensor.

SMALL | MEDIUM | LARGE
   


On engines equipped with engine brakes, connect the engine brake harness to the sensor harness.

Wire tie the harness to the fuel tubing at the rear of the engine.

SMALL | MEDIUM | LARGE
Last Modified:  20-Mar-2012
Avatar photo

Published by Jack

Hello, I'm Jack, a diesel engine fan and a blogger. I write about how to fix and improve diesel engines, from cars to trucks to generators. I also review the newest models and innovations in the diesel market. If you are interested in learning more about diesel engines, check out my blog and leave your feedback.