Symptom Tree
|
Fuel level is low in the tank |
Fill the supply tank. Refer to the OEM service manual. |
 |
|
Electronic fault codes are active |
For instructions on how to read active fault codes, refer to Procedure 101-007 (Electronic Controlled Fuel System) in Section 1. If fault codes are active, contact a Cummins Authorized Repair Facility. |
|
|
Engine is cold |
Allow the engine to warm up for approximately 1 to 3 minutes. Refer to Procedure 101-015 (Operating the Engine) in Section 1. |
|
|
Fuel leak |
Check the fuel lines, fuel connections, and fuel filters for leaks using the combustible gas detector service tool. Refer to a Cummins Authorized Repair Facility. |
|
|
Battery voltage is low |
Check the batteries and the unswitched battery supply circuit. Refer to the OEM service manual. |
|
|
Accessory load is excessive for the idle speed setting |
Reduce the accessory load or increase the engine idle speed. Refer to the OEM service manual. |
|
|
Ignition coil malfunctioning |
Check the ignition coil. Refer to Procedure 013-012 (Ignition Coil) in Section 6. |
|
|
Spark plug(s) damaged or incorrect gap |
Inspect plug(s). Refer to Procedure 013-016 (Spark Plugs) in Section 6. |
|
|
Oil from the fuel has accumulated on the gas mass flow sensor, screen packs, or elsewhere in the fuel system |
Check for oil in the fuel system. Refer to a Cummins Authorized Repair Facility. |
|
|
Intake air restricted |
Inspect and change air cleaner. Look for other restrictions. Refer to Procedure 010-059 (Air Cleaner Restriction) in Section 4. |
|
|
Overhead adjustments are not correct |
Measure and adjust the overhead settings. Refer to Procedure 003-004 (Overhead Set) in Section 6. |
|
| Contact a Cummins Authorized Repair Facility |
