Centinel System – Repair Manual – 001-079   Gear Cover, Upper

Install a new strip seal. Orient the overlap at the top and center of the gear housing.

Use a small amount of RTV at the overlap joint of the strip seal.

WARNING  This component weighs 23 kg [50 lb] or more. To reduce the possibility of personal injury, use a hoist or get assistance to lift the component.

Install the cover with 16 capscrews.

Tighten the capscrews in the sequence shown.

Install a new strip seal. Orient the overlap at the top and center of the gear housing.

Use a small amount of RTV at the overlap joint of the strip seal.

WARNING  This component weighs 23 kg [50 lb] or more. To reduce the possibility of personal injury, use a hoist or get assistance to lift the component.

Some industrial applications use a stamped steel cover with a clamping plate.

Install two guide pins in the gear housing.

Install the front gear cover over the guide pins.

Install the clamping plate, if used.

Install 14 capscrews.

Remove the two guide pins and install the last two capscrews.

Tighten the capscrews in the sequence shown.