Sensors for mid-1994 to 1996 models are marked C96 or C 97; C-92 sensors were used from late-1997 to the end of production. These OEM…
Author: Ed
I'm Ed, a blogger who loves diesel engines. I share tips, reviews, and stories about repairing and maintaining them. Join me on my blog and learn more about the diesel world.
Air leaks can cause rough idle, shutdowns on deceleration, and no-starts. The time required for air intrusion to make itself known depends upon the proximity…
Aeration often results in hard or no-starts, erratic idle, shutdowns on deceleration, and loss of rpm. CG4/SH oil helps control the problem. As originally specified,…
If you have not already done so, check the oil level in the pump reservoir, which should come to within an inch of the top…
A frequent complaint is a rough idle, which can originate from the fuel system or from one or more weak cylinders. Follow this procedure: 1.…
Begin with a walk-around the vehicle to determine that the tank is at least a third full, batteries are charged, battery terminals are clean and…
Four engines, three of them built by International, go by the name “Power Stroke.” The first was the direct injection turbocharged 7.3L V-8. This engine,…
Table 6-3 lists the most critical DTCs for this system. PID (parameter identifier) is a two- or three-digit SAE numerical code assigned to each component.…
The TPS is located under the accelerator pedal and generates a pulse-width signal that can read with a Fluke Model 97 or equivalent multimeter and…
HEUI evolved from the EUI, and since mid-1994 has been used on Caterpillar, International T444E, DT466E, 1530E, certain Perkins models, and, most famously, on the…