C15 – 0054-05 Auxiliary Output #06 current low (66)

Conditions Which Generate This Code:

The ECM detects the following conditions:
• There is a low current condition (open circuit) in the circuit for the lockout solenoid for more than two seconds.
• The “Transmission Style” is programmed to “Eaton Top 2”.

System Response:
The solenoid that is currently enabled will remain in the ON position until neutral is detected.
Then manual operation occurs until the system powers down. Manual operation is defined as both solenoids OFF.

Possible Performance Effect:
The ECM disables the Eaton Top 2 mode.

Troubleshooting:
Perform the following diagnostic procedure: “Eaton Top 2 Transmission Circuit – Test”

Results:
• OK – STOP.

Leave a Reply

Your email address will not be published. Required fields are marked *