Table of Contents Remove Inspect for Reuse Install Remove TOC Remove the Freon compressor drive belt, if equipped. Refer to the manufacturer’s instructions. Remove the…

Table of Contents Remove Clean Inspect for Reuse Install Remove TOC Remove the fuel pump. Refer to Procedure 005-016. Remove the air compressor, if equipped.…

Drive Units Tool Number 3823774 Needle Bearing Kit Used to remove and install needle bearings in the hydraulic pump adapter. Use mandrel, Part No. 3823776,…

Table of Contents General Information Initial Check Remove Install General Information TOC This procedure applies to engine using an electric fan clutch controlled by the…

Table of Contents General Information General Information TOC The coolant flow to provide torque converter cooling is achieved in different manners. M11 engines use a…

Table of Contents Remove Clean and Inspect for Reuse Install Remove TOC  WARNING  Do not remove the pressure cap from a hot engine. Wait until…

Table of Contents Initial Check Initial Check TOC Shutters and thermatic fans must be set to operate in the same temperature range as the thermostat…

Table of Contents Inspect for Reuse Inspect for Reuse TOC Be sure the correct radiator cap is being used. Refer to “Cooling System Specifications.” Inspect…

Table of Contents Inspect for Reuse Inspect for Reuse TOC Inspect all hoses for cracks, cuts, or collapsing. NOTE: The silicone engine coolant hose will exhibit…

Table of Contents Initial Check Initial Check TOC  WARNING  Wear appropriate eye and face protection when using compressed air. Improper use can cause bodily injury…