Table of Contents Preparatory Steps Remove Clean and Inspect for Reuse Redowel Install Measure   Bore Alignment Face Alignment Finishing Steps Preparatory Steps TOC  WARNING …

Table of Contents Preparatory Steps Remove Clean Inspect for Reuse   Rail Applications Measure   Bore Runout Face Runout Install   Rail Applications Finishing Steps…

Table of Contents Remove Clean Inspect for Reuse Install Remove TOC Use a hoist or lifting fixture to support the front of the engine. Remove…

Table of Contents Remove Clean Inspect for Reuse Install Remove TOC Remove the four capscrews and the rear lifting bracket. SMALL | MEDIUM | LARGE Next Remove the four…

Mounting Adaptations Tool Number ST-1134 Dowel Pin Extractor Use to pull dowel pins. Tool Number ST-1232 Drill Ream Fixture Use to accurately drill and ream…

Table of Contents General Information General Information TOC When it is not possible to load an engine immediately after rebuild or repair (example: on-highway tractor…

Table of Contents Run-In Instructions Run-In Instructions TOC Measurements from these indicators and gauges must be observed closely during all phases of the engine run-in…

Table of Contents Setup   Coolant Plumbing Intake Air Temperature Control Intake Air Restriction Exhaust Air Restriction Lubricating Oil Pressure Intake Manifold Pressure Engine Blowby…

Table of Contents Run-In Instructions   On-Highway Applications Run-In Instructions TOC On-Highway Applications  CAUTION  Refer to “Engine Testing — General Information” and “Specifications — Engine…

Table of Contents Run-In Instructions Run-In Instructions TOC Refer to Chassis Dynamometer Operation, Procedure 014-002-011, for general operating procedures and safety precautions. Operate the vehicle…