Table of Contents Install Measure   Bore Alignment Face Alignment Install TOC  CAUTION  If a new flywheel housing is being installed, the dowels must be…

Table of Contents Install Install TOC The following procedure is with removing the rear cover plate: Install a new gasket onto the cylinder block. Install…

Table of Contents Install Install TOC Install new belts onto the pulley. When a drive pulley uses two or more belts, replace the belts as…

Table of Contents Install Install TOC Install the new fan hub and the capscrews. Hand tighten the capscrews. SMALL | MEDIUM | LARGE Next Install the fan drive belts…

Table of Contents Install Install TOC Install a new belt onto the pulleys. Turn the adjusting screw to adjust belt tension. NOTE: Belt tension can increase…

Table of Contents Install Install TOC Make sure the sensor has an o-ring before installing it in the engine. Install the coolant temperature sensor in…

Table of Contents Install Install TOC NOTE: The N14 CELECT™ and CELECT Plus™ engines has one engine coolant thermostat and one aftercooler thermostat. The N14 STC…

Table of Contents Install Install TOC NOTE: If rubber grommets are used on the coolant lines, make sure they are installed carefully to prevent cuts or…

Table of Contents Install Install TOC  CAUTION  The water pump must have a dowel pin locating hole (2) and an oil cooler return passage (1).…

Table of Contents Install Install TOC Install the dust seal by hand over the flange on the back of the pulley. Position the seal so…