019-061   Intake Manifold Pressure Sensor

Table of Contents

Remove
Install

Remove

TOC

Lift up on the tab and disconnect the connector from the sensor.

Remove the sensor from the air intake manifold with deep flank drive socket, Part Number 3823843.

SMALL | MEDIUM | LARGE

Install

TOC

Make sure the new sensor has an o-ring around the surface where it seals against the air intake manifold.

Install the sensor into the air intake manifold by turning it

clockwise.

Torque Value:  14  n.m  [124 in-lb]

SMALL | MEDIUM | LARGE
   


Push the harness connector into the sensor until it locks.

SMALL | MEDIUM | LARGE
Last Modified:  10-Feb-2003

Leave a Reply

Your email address will not be published. Required fields are marked *